Your Build Sheet Isn't the Whole Fitting. Here's What Else to Leave With.

The fitting's over.

You've got a build sheet in your hand. Head, shaft, length, loft, lie, grip.

It looks complete.

It might not be.

A good fitting ends with more than a spec sheet. Some of what was done to your club doesn't look like a spec at all. And some of what you need is a plan for after you leave.

The settings that hide

A lot of clubs today can be adjusted after they're built.

The adapter on the hosel can sit in different positions. Weights can be moved around the head. A loft or lie can be bent.

Every one of those changes how the club plays.

And every one of them is easy to leave off the sheet, or to bury in a code you won't understand six months from now.

So before you leave, make sure you know:

Where the adapter is set.
Not just "it's adjusted." The actual position.

Where the weights are.
If the head has movable weights, where did they end up?

Whether anything was bent.
Lofts, lies, which clubs. If something was bent, it should be written down.

Which shaft was chosen.
The exact one, not just a flex.

Why does this matter so much?

Because a setting nobody wrote down can't be checked. And it can't be put back.

A setting isn't sacred

A lot of golfers treat a fitting result like it's permanent.

The fitter set the sleeve a certain way, and now nobody touches it. They're afraid of undoing the fitting.

I understand the instinct. But adjusting a golf club isn't surgery. An adapter setting can be changed back in a minute.

That only works if you know where it started.

Your swing changes. Your equipment changes. Your conditions change. A fitting's value depends on all of those staying the same, and none of them do.

Write the settings down, and you can always put the club back to where the fitting left it.

The other two things on the list

You should also know what problem each change was meant to solve and what the fitter is less sure about, and The build sheet page shows you how to ask.

Then there are two things that are easy to skip.

What to do if something feels off

The bay isn't the course.

Different turf. Different lies. Different pressure. The whole ball flight, not a screen.

Sometimes a club that felt great inside feels a little different the first few times you play it.

That doesn't automatically mean the fitting was wrong. It could be the build, your swing, or just a new club in real conditions. Either way, you should know what to do about it before you leave.

So ask:

If this doesn't feel right on the course, what should I do?

What should I watch for?

Is there anything I should leave alone for a while before I decide?

You're not looking for a guarantee. You're looking for a plan.

When to come back

This one is worth asking about every time.

Some fittings end with a receipt.

Some end with something like "see you in a couple of weeks, after you've played a few rounds."

Those are two different kinds of fittings.

One treats the appointment as the finish line. The other treats it as the first look at a club you're going to keep learning about.

There's no single right amount of time. That depends on you, the club and the fitter. But you should know before you leave whether there's a next step, and what it is.

If nobody brings it up, bring it up yourself.

This isn't a knock on anybody. The limitation is often the fitting format, not the fitter. There's a lot to get through in one session, and the plan for afterward is easy to skip when everyone's focused on the order.

Before you order

Look at what you were given.

Is every setting on there? Do you know what to do if something feels off? Do you know when to come back?

If you can answer those, order when you're ready.

If you're still not sure about something, send the build sheet and the question you still have. It's free, and a person will look at what you were given and reply by email.

You can do that on Before you order.

The build sheet is where the fitting gets written down. It isn't where the fitting ends.